VESTA-193
Last updated
Was this helpful?
Last updated
Was this helpful?
Charging Cradle
Mobile Lite is powered by rechargeable battery. The typical charging time is 4 hours. As the battery may not be 100% charged when you get your Mobile Lite, make sure to charge your Mobile Lite before the first use.
To Charge Mobile Lite, please place Mobile Lite into the Charging Cradle, making sure that the Charging Contact Plates (of both Mobile Lite and the cradle) are in contact with each other, and then connect the Charging Cradle to power supply (Refer to 3.2. Charging Mobile Lite of the Mobile Lite Installer Guide).
Step 1. Loosen the Cover Fixing Screws using a Philips screwdriver and remove the SIM Card Protective Cover.
Step 2. Insert SIM Card into Mobile Lite, the chip side of the SIM card should face the front side of Mobile Lite as you insert the card.
Step 3. Replace the Protective Cover and tighten the Protective Cover Fixing Screws using a Philips screwdriver.
Note:
Use a SIM card with correct size that can fit in the SIM card slot. If you don’t have the right SIM card size, please contact your service provider for a replacement of SIM card.
Do not insert a SIM card with a SIM card adapter or it will cause damage to the SIM card and its holder.
Please make sure that the SIM card PIN code is deactivated and all SMS messages removed before insertion.
Step 1.
Attach the lanyard to the Mobile Lite unit by looping the lanyard strap through the lanyard holes on the Mobile Lite unit, and then pulling the strap through until it is tight.
Step 2.
Lock the release buckle by inserting the male part into the female part until you hear a click sound.
Step 3. Put the lanyard around the neck of the user.
To use PC Programming Tool for programming Mobile Lite, follow the steps below:
Step 1.
Loosen the Protective Cover Fixing Screws using a Philips screwdriver and remove the SIM Card and USB Protective Cover.
Step 2.
Insert the device/cradle end of the
Programming Micro-USB Cable into the
Micro-USB jack as shown in the picture:
Step 3.
Insert the programming/charging end of the Programming Micro-USB Cable into a computer USB port.
WARNING
If programming cable is not provided, please contact your supplier. DO NOT attempt to connect Mobile Lite to computer with a regular Micro-USB cable.
Mobile Lite can be programmed via USB port connection of a computer using the PC Programming Tool software (using the Programming Cable). The USB Driver must be installed first for your computer to recognize the panel. Please go to http://www.ftdichip.com/Drivers/VCP.htm to download and install the driver according to your operation system.
Power on your PC and follow the steps below to install the firmware.
Enter https://www.climax.com.tw/climax-download-mobile-lite-r3-qt.html in the address bar.
Download the PC programming Tool (MobileTool Vx.x).
For more detailed instruction, please download
“Mobile Lite R3-QT Installer Guide” from Climax’s website.
■ https://www.climax.com.tw/climax-download-mobile-lite-r3-qt.html
