SmartHomeSec WIZARD
Last updated
Was this helpful?
Last updated
Was this helpful?
This wizard is coming soon
Press No, we will end the Wizard and we can proceed to configure the control panel manually
Press Yes, and the panel configuration Wizard will start
Enter the default installer code: 7982 and press Login
NOTE: During the Wizard we could at any time access the various steps of the guided configuration by pressing the icon with three lines at the top left
We may have created one or more programming templates to recall them at this stage and avoid always setting the same parameters during a system configuration.
Press Skip, we will go forward in the wizard
Press Yes, we will load a previously saved programming template.
Select a script model (previously created). All parameters set in the template will be automatically sent to the control panel.
You can see the parameters of the model simply by clicking on the three dots
Press Save and Next
In this phase we will create a new account for the customer, the account will be his login to be able to connect with the SmartHomeSec App or through the WEB portal to be able to manage the system.
Press Skip, we will go forward in the wizard
Press Yes, we could add a new account or link the control panel to an existing customer account
On this screen, we could decide whether to create a new user account or connect the control panel to an existing customer account
Create Account
ID: Customer name or email
Password
Customer email
Customer Access Privilege
Customer Access Privilege. The customer will be able to:
Media Request – Request images from PIRCAM
Notification – Receive notifications
Automation – Access the automation section
Camera – Access the camera view
Event – Access the events page of the control panel
Area (1,... 8) – The user will have access to the specified partitions of the system
Link to an existing account
By clicking “link to an existing account”, we could enter the customer's (ID and Password) and configure the access rights and associated areas.
In this tab, we can customize the customer's PIN code.
Skip, we will jump to the next step
Press Yes, and we will configure the name and code of the end user.
In this screen, we could add any magnetic contact, PIR, detectors, PirCam, Cameras, and other accessories to the control panel
Press Skip, we will go forward in the wizard
Press Yes, the control panel will ask you which device you want to add
Select the device type you want to add, e.g., Motion Detector. Press and hold the pairing button on the device until the LED flashes (refer to the device's manual for specific instructions).
Important! In case of PIRCAMS and keyboards: The keystroke must be 3 or 4 seconds. While the rest of the devices with a short press is enough to add them.
Follow the on-screen instructions to complete the pairing process. The panel will confirm the successful addition of the device.
Select the device and press Submit
To configure the zones correctly, it is important to be familiar with the available attributes and their impact on the behavior of the alarm system.
For example: Interior is an instant zone and Entry is a delayed zone; we can assign these attributes in the section Response on arming which means "When the system is armed."
In this tab, we will define the security settings relating the partition of the control panel.
e.g. Entry time, exit time, ....
In this tab, we could customize the options of the control panel
In this tab, we will be able to enable the GSM module of the control panel
Press Skip will cause the panel to use the Ethernet connection
Press Yes, we could enable SIM detection and set the APN if necessary
This tab allows us to configure the sending of events and any images of the pircams to a Central Monitoring Station.
Press Skip, the control panel will send all events to the end user's app
Press YES, we will configure the control panel to send events to a Central Monitoring Station.
We can apply a template already configured with the settings for the connection to the Central Monitoring Station.
Click on the + icon to add a second communication method (the first is always the cloud and cannot be changed), select "Group 2" and set the parameters provided by the Central Monitoring Station.
Set up group 2 with 3 attempts, at the end press Save and then Next
