# VESTA-349
VCP-LTE-SV Quick Start Guide
## Voice Emergency Call Point
## **1. Package Content**
Voice Call Point A power supply (DC 9V 1A SPS adaptor) A Wall Mounting Bracket
## **2. Identifying the Parts**
## **3. Power Supply**
A DC 9V 1A SPS power adapter is provided for AC power connection.
In addition to the AC power adapter, a rechargeable battery is installed inside VCP-LTE-SV to serve as a backup in case of a power failure.
You need to switch the battery switch to ON for the battery to be charged when AC power is connected and serve as a backup power source when AC power is missing.
## **4. Hardware Installation**
**Insert SIM card**
• It is recommended to disable the SIM card PIN code before inserting into the VCP-LTE-SV.
• The SIM card base is located on the back side of the unit.
• Push to the furthest extend, then press on the edge of the SIM card firmly to secure it.
• SIM Card will delete its SMS messages whenever the VCP-LTE-SV is powered on.
{% hint style="danger" %}
Note:
* *Only a Nano SIM card can fit in the SIM card slot. If you don’t have the right SIM card size, please contact your service provider for a replacement of SIM card.*
* *Do not insert a SIM card with a SIM card adapter or it will cause damage to the SIM card and its holder.*
{% endhint %}
### **Wall Mounting**
**Step 1.** Break through the 2 knockouts on the Wall Mounting Bracket.
**Step 2.** Use the 2 holes as a template to mark off the holes’ positions, making sure that the triangle symbol on the bracket points straight up.
**Step 3.** Drill 2 holes and screw the bracket onto the wall.
**Step 4.** Connect a DC 9V 1A SPS power adapter to the DC jack of VCP-LTE-SV and keep the cable well-placed.
**Step 5.** Fit VCP-LTE-SV onto the mounting bracket. Make sure the imprinted mark on VCP-LTE-SV is aligned with the upper mark on the bracket.
**Step 6.** Rotate VCP-LTE-SV clockwise to the lock position.
### **Surface Placement**
**Step 1.** Clean the back of VCP-LTE-SV with degreaser. Connect a DC 9V 1A SPS power adapter to the DC jack and keep the cable well-placed to the right or left.
**Step 2.** Remove the protective cover of Anti-Slip pad and apply to the back of VCP-LTE-SV.
**Step 3.** Place VCP-LTE-SV at the desired location.
## **5. Software Installation**
VCP-LTE-SV can be programmed via USB port connection of a computer using the PC Programming Tool software (with the Programming Cable). The USB Driver must be installed first for your computer to recognize the USB connection. Please go to to download and install the driver according to your operation system.
* Power on your PC and follow the steps below to install the firmware.
* Enter **** in the address bar.
* Download the PC programming Tool (MobileTool).
* For more detailed instruction, please download “ VCP-LTE-SV Voice Call Point Installation Guide ”.
* **
